Mgeorgia Posted February 6, 2013 Share Posted February 6, 2013 hello!!! i have four vehicles that go to a sink. i want to run the simulation and the one ot them not to start. when i start again the simulation i want all of them to start . is there a way to do it easily? thanks a lot! Link to comment Share on other sites More sharing options...
jdoran Posted February 7, 2013 Share Posted February 7, 2013 You could make two vehicle groups (in lists), and in your seize block reference a property that points to one of the lists. You could then run an experiment with multiple scenarios where you toggle between the two lists. Link to comment Share on other sites More sharing options...
Mgeorgia Posted February 8, 2013 Author Share Posted February 8, 2013 thanks! Link to comment Share on other sites More sharing options...
rahulr1988 Posted January 4, 2015 Share Posted January 4, 2015 I have a similar issue!!! i have total of 15 vehicles and i want the number of vehicles to change based on data table each week. Example: Week 1 --> 8 vehicles Week 2 --->7 Vehicles Week 3 --->10 Vehicles and so on... Is there any way to do this?? Link to comment Share on other sites More sharing options...
Recommended Posts