Jump to content
Simio Forum
Mgeorgia

vehicle process

Recommended Posts

hello!!!


i have four vehicles that go to a sink. i want to run the simulation and the one ot them not to start. when i start again the simulation i want all of them to start . is there a way to do it easily?




thanks a lot!

Share this post


Link to post
Share on other sites

You could make two vehicle groups (in lists), and in your seize block reference a property that points to one of the lists.


You could then run an experiment with multiple scenarios where you toggle between the two lists.

Share this post


Link to post
Share on other sites

I have a similar issue!!! i have total of 15 vehicles and i want the number of vehicles to change based on data table each week.

Example: Week 1 --> 8 vehicles

Week 2 --->7 Vehicles

Week 3 --->10 Vehicles and so on...

Is there any way to do this??

Share this post


Link to post
Share on other sites

×