Jump to content

AssociatedStationOverload is always -infinity


Recommended Posts

I am recreating the model 5.3 of the Simio and Simulation textbook. When I create the list and run the model, with selection expression in the output@placement node as below candidate.Node.AssociatedStationOverLoad, all entities goes only to finepinchfaststation. However, when I use Candidate.Node.AssociatedStationLoad it selects all desitnation loads. Is there any change to the Candidate.Node.AssociatedStationOverLoad? I displayed the values in the facility window and it is coming as -infinity.

Model_05_02.spfx

Edited by Sreenath Chalil Madathil
Link to comment
Share on other sites

  • 1 month later...

Yes, the buffer is set to 0 in the model distributed with the book.  The book verbiage mentions that using Infinity for buffers will cause a tie in the selection logic, but we need to add some additional discussion about the differences between using values of 0, 1, 2, etc. for the buffer capacities.

Link to comment
Share on other sites

×
×
  • Create New...