Simio
  • vehicle process

  • General Simio discussions. THIS IS *NOT* A GOOD PLACE FOR SUPPORT QUESTIONS.
    To limit spam this and all Public Forums have very limited ability to attach files. We recommend that support issues and more technical topics be initiated inside one of the Simio Insider (SI) forums below where you can attach your model and see example solutions. See above Welcome forum to join Simio Insiders.
General Simio discussions. THIS IS *NOT* A GOOD PLACE FOR SUPPORT QUESTIONS.
To limit spam this and all Public Forums have very limited ability to attach files. We recommend that support issues and more technical topics be initiated inside one of the Simio Insider (SI) forums below where you can attach your model and see example solutions. See above Welcome forum to join Simio Insiders.
 #3213  by Mgeorgia
 Wed Feb 06, 2013 9:01 am
hello!!!

i have four vehicles that go to a sink. i want to run the simulation and the one ot them not to start. when i start again the simulation i want all of them to start . is there a way to do it easily?



thanks a lot!
 #3220  by jdoran
 Thu Feb 07, 2013 5:01 pm
You could make two vehicle groups (in lists), and in your seize block reference a property that points to one of the lists.

You could then run an experiment with multiple scenarios where you toggle between the two lists.
 #6192  by rahulr1988
 Sat Jan 03, 2015 11:05 pm
I have a similar issue!!! i have total of 15 vehicles and i want the number of vehicles to change based on data table each week.
Example: Week 1 --> 8 vehicles
Week 2 --->7 Vehicles
Week 3 --->10 Vehicles and so on...
Is there any way to do this??